Jay-tech DS100 User Manual - 9. Cleaning & Maintenance

17

Periodically and after consistent use the film scanner should be 

cleaned using compressed air canister to clean the dust out of the 

inside chamber.

◆

Place the film scanner on the side and insert the end of straw 

from the compressed air into door on the right side so that it 

opens.

◆

Gently blow out any dust on the inside of the film scanner.

    Note: Compressed air is not included with the film scanner but 

can be purchased from an office supply or electronics retailer.

You can also use the provided brush to clean the backlight panel

◆

Place the film scanner on the side and insert the end of the  

brush into the door on the right side

◆

Clean the backlight panel placed in the film scanner

For further cleaning you can use an ordinary cotton swab and a 

bottle of lens cleaning fluid

◆

Wet the end of the cotton swab with Lens Cleaning Fluid and 

insert into the right side of the film scanner so the door opens. 

Then clean the entire surface of the glass on the inside of the 

film scanner with the cotton swab.

Note: Cotton swabs and cleaning fluid are not included with the 

film scanner but can be purchased from an office supply, photo 

supply or electronics retailer.

When not in use please disconnect the film scanner from the 

computer and store in a clean, dry and dust-free environment.

Note: You may see a thin black or white edge line on your picture 

due to non exact size old negatives. This is normal.

9. Cleaning & Maintenance