Jaycar Electronics LA-9011 User Manual - page 3
Contents
Before Use
1. Installing The SIM Card
Remove the battery cover according to the following diagram below. Remove the battery exposing the SIM card
socket. Push the SIM card metal cover up to release the socket and place the SIM card into the socket (ensure that
the SIM card contact is facing down). Cover the SIM card metal cover and push to the “LOCK” position to lock the
SIM card, and then put the battery in and lock the battery cover.
Note: 1. The tracker uses a 2G GSM network, it uploads tracking only through GPRS. It can not work on a CDMA
or 3G (WCDMA or CDMA2000) network. (Some 3G SIM cards can be used on a 2G GSM network, this
SIM card can be used in this tracker)
2. Please confirm the PIN code of the SIM card is disabled.
3. Before installing or uninstalling the SIM card, please power off the tracker
2. Power ON/OFF
•
When power is OFF, please press the “ON/OFF” button until the GREEN LED turns ON.
•
When power is OFF, connect the power to12V or24V source, the tracker will power on automatically.
When the power is ON, press and hold the “ON/OFF” button until the GREEN LED flashes to turn the tracker OFF.
When the battery voltage in the tracker is too low, the tracker will power off automatically.
3. LED Flash Indicator
GREEN LED Flashes once
:GSM & GPS work correctly
GREEN LED Flashes twice
:GSM working correctly, no GPS signal
GREEN LED Flashes three times
:GSM & GPS working correctly, battery is low
GREEN LED Flashes four times
:GSM working correctly, battery is low and no GPS signal