Jaycar Electronics LA9015 Quick Manual - page 8
-8-
Note: Only The authorized phone can change the password.
Check tracker password
Send SMS “CHECKPASSWORD” to the tracker, “CHECKPASSWORD” is a command, if the operation is
success, the tracker will send back the information “Password
:
888888”; “888888”is an example.
Note: Only The authorized phone can check the password.
3. Set APN & GPRS
This tracker use GPRS to upload the information to internet server, most mobile company SIM card need
enable GPRS service first & set APN and GPRS user name & password, please call your tracker SIM card
mobile phone company to confirm.
This tracker can download & configure APN & GPRS username password automatically after power on
according the different SIM card in the tracker, if the APN & GPRS user name password are not right (Red LED
will flash twice), then you need sending SMS to tracker to change them manually, please confirm the auto
configuration of APN & GPRS user name password is right, call your tracker SIM card mobile phone company
to get the APN & GPRS setting, sending SMS “CHECK*123456” to tracker can check the current APN & GPRS
auto setting. If the APN & GPRS are not right, please set by the following description.
Send SMS “APN*123456*apnname” to the tracker, in which, “APN” is the fixed command, “123456” is the
password and “apnname” is the APN name of a mobile phone company. Having successfully been made, there
will be a SMS “APN: apnname”.
Send SMS “USERNAME*123456*username*password” to the tracker, “USERNAME” is a command,
“123456” is the password of the tracker; “username” is the mobile company GPRS user name, “password” is
the mobile company GPRS password, if the operation is success, the tracker will send back the information
“Username: username, Password: password”, please call the mobile phone service hot-line to get the GPRS
username and password, some mobile company it is not necessary to set the GPRS username and password.
If the password is not right, the operation is fault; the tracker will send back information “Wrong Password”.
4. Set Website Server IP address
The tracker IP address has been set to default: 58.64.155.133,8011 in factory. Normally this is not
necessary to change, If our server IP is changed, we will notice on the website. But if you need upload location
to your own server, send SMS “IP*123456*58.64.155.133,8011” to the tracker, in which, “IP” is the fixed
command, “123456” is the password and “58.64.155.133,8011” is the IP address & port of the your own server.
Having successfully been set, there will be a SMS “IP: 58.64.155.133,8011”.
5. Set the system GSM work mode
The tracker has 3 GSM work modes.