JB Systems ACCU COLOR Operation Manuals - [Setup Menu]:
ENGLISH
USER MANUAL
JB Systems
®
6/13
Accu Color
USING THE TRANSPARANT COVER
•
INDOOR USE (IP20):
you can use the projector without the transparent cover.
•
OUTDOOR USE (IP43):
you can use the plastic transparent cover to avoid rain
from entering the projector.
Attention: this does NOT mean that the projector now becomes full
waterproof! It’s only protected against occasional rain!
[SETUP MENU]:
MAIN MENU:
•
To select any of the menu options, press the
[MENU]
button.
•
Use
▲ and ▼ button to choose the desired menu option..
•
Select the function with the
[ENTER]
button. The display will blink.
•
Once the required menu option is selected, press the
[ENTER]
button to select.
•
Press the
[MENU]
button to return to running mode.
[Addr] DMX 512 Address setting
Used to set the start address in a DMX setup.
•
Press the [MENU] button.
•
Press the
▲ or ▼ button until
[Addr]
is shown on the display.
•
Press the [ENTER] button to select. The display starts blinking.
•
Use
▲ and ▼ buttons to change the DMX512 address.
•
Once the correct address is shown on the display, press the [ENTER] button to
confirm.
[CHnd] Channel Mode
The unit has 5 different channel modes, refer to the DMX-chart to see the
differences.
•
Press the [MENU] button.
•
Press the
▲ or ▼ button until
[CHnd]
is shown on the display.
•
Press the [ENTER] button to select. The display starts blinking.
•
Use
▲ and ▼ buttons to select one of the available channel modes.
•
Once the mode is selected, press the [ENTER] button to confirm.
[SLAU] Slave Mode
The first projector in the chain should be set , all the other projectors have to be in
Slave mode.
•
Press the [MENU] button.
•
Press the
▲ or ▼ button until
[SLAU]
is shown on the display.
•
Press the [ENTER] button to select. The display starts blinking.
•
Then press [ENTER] to confirm the slave mode.
[SP--] Speed Mode
•
Press the [MENU] button.
•
Press the
▲ or ▼ buttons until
[SP--]
is shown on the display.
•
Press the [ENTER] button to select. The display starts blinking.
•
Use
▲ and ▼ buttons to select the desired speed.
[Pr--] Preset Selection Mode
Used to choose to select one of the preprogrammed colors or fades when used
in standalone or master/slave mode. All projectors will always show an
identical output.
•
Press the [MENU] button.
•
Press the
▲ or ▼ buttons until
[Pr--]
is shown on the display.