JB Systems COB-4BAR Operation Manual - page 8
ENGLISH
USER MANUAL
JB SYSTEMS
®
6/16
COB-4BAR
SLAVE MODE + FOOT CONTROLLER
Used to set the unit in slave mode when you want to have synchronized effects with the master unit.
(when the first unit is running it’s automatic programs or is set in a fixed color)
Used when you want to control the bar with the optional foot controller
Press the MODE button until
SLAVE
is shown on the display.
Press the ENTER button to confirm.
IMPORTANT: If you want to use the automatic modes and make the settings directly on the bar, you
need to deactivate the IR remote control receiver in the bar. (IR ACTIVE = OFF)
SOUND MODE
Used to set the parameters for the automatic Sound Mode.
Press the MODE button until
SOUND MODE
is shown on the display.
Press the ENTER button to enter the configuration mode
The value of the sensitivity (SENS) will start blinking on the display
Use DOWN and UP buttons to change the sensitivity of the build-in microphone (00 = minimal sensitivity,
31 = maximal sensitivity).
Press the ENTER button to confirm.
The value of the frequency (FQN) will start blinking on the display
Use DOWN and UP buttons to change the number of times each automatic program should be repeated
before to go automatically to the next automatic program.
Press the ENTER button to confirm.
IMPORTANT: Don’t forget the bar is equipped with a master dimmer. If the output seems to be too
low or if there is no light output at all, please check the MASTER DIM setting !
STATIC COLOR MODE:
Used to set a static color for the projectors.
Press the MODE button until
01.STATIC
or
xx.EFFECT
(number 02 to 14 followed by EFFECT) is shown
on the display.
Press the ENTER button to enter the configuration mode
The actual mode (static or effect mode) is blinking on the display
If necessary, use the DOWN and UP buttons to select
01.STATIC
Press the ENTER button to enter the configuration mode for the static colors
Use DOWN and UP buttons to select
COLOR_CW
(cold white),
COLOR_WW
(warm white) or
COLOR
SET
(to compose your own color).
If you have chosen
COLOR_CW
or
COLOR_WW
: just press the ENTER button to confirm your choice
If you have chosen
COLOR SET
: press the ENTER button to access the manual color settings
RED
is blinking on the display: use the DOWN and UP buttons to set the intensity of the red color
(000 = minimum, 255 = maximum)
Press the ENTER button to confirm and to go to the next color
GREEN
is blinking on the display: use the DOWN and UP buttons to set the intensity of the green
color (000 = minimum, 255 = maximum)
Press the ENTER button to confirm and to go to the next color
BLUE
is blinking on the display: use the DOWN and UP buttons to set the intensity of the blue
color (000 = minimum, 255 = maximum)
Press the ENTER button to confirm
IMPORTANT: Don’t forget the bar is equipped with a master dimmer. If the output seems to be too
low or if there is no light output at all, please check the MASTER DIM setting !
SLOW COLOR FADE MODE:
Used to let the projectors slowly fade from one color into another.
Press the MODE button until
01.STATIC
or
xx.EFFECT
(number 02 to 14 followed by EFFECT) is shown
on the display.
Press the ENTER button to enter the configuration mode
The actual mode (static or effect mode) is blinking on the display
Use the DOWN and UP buttons to select
02.EFFECT (fading from one color into another) or
04.EFFECT (each color fading on and off)
Press the ENTER button to confirm