JB Systems COB-4BAR Operation Manual - page 9
ENGLISH
USER MANUAL
JB SYSTEMS
®
7/16
COB-4BAR
Speed starts blinking on the display: Use the DOWN and UP buttons to set the desired running speed (00
= slow, 99 = maximum speed)
Press the ENTER button to confirm
Flash starts blinking on the display: Use the DOWN and UP buttons to set the desired speed for the
stroboscopic effect (00 = off, 99 = maximum speed)
Press the ENTER button to confirm
IMPORTANT: Don’t forget the bar is equipped with a master dimmer. If the output seems to be too
low or if there is no light output at all, please check the MASTER DIM setting !
AUTOMATIC CHASE MODE:
Used to set the automatic Chase Mode so colors will change automatically at a constant speed.
Press the MODE button until
01.STATIC
or
xx.EFFECT
(number 02 to 14 followed by EFFECT) is shown
on the display.
Press the ENTER button to enter the configuration mode
The actual mode (static or effect mode) is blinking on the display
Use the DOWN and UP buttons to select one of the 11 chase modes (03, 05, 06, 07, 08, 09, 10, 11, 12, 13
or 14.EFFECT).
Press the ENTER button to confirm
Speed starts blinking on the display: Use the DOWN and UP buttons to set the desired running speed (00
= slow, 99 = maximum speed)
Press the ENTER button to confirm
Flash starts blinking on the display: Use the DOWN and UP buttons to set the desired speed for the
stroboscopic effect (00 = off, 99 = maximum speed)
Press the ENTER button to confirm.
Remark:
if you have selected
13.EFFECT
or
14.EFFECT
, you can choose 2 colors for your chase program:
C1 will blink on the display
Use the DOWN and UP buttons to and UP buttons to select the first color of your chase program.
Press the ENTER button to confirm
C2 will now blink on the display
Use the DOWN and UP buttons to and UP buttons to select the second color of your chase program.
Press the ENTER button to confirm
IMPORTANT: Don’t forget the bar is equipped with a master dimmer. If the output seems to be too
low or if there is no light output at all, please check the MASTER DIM setting !
AUTO RUN:
Used to start the automatic Random Chase Mode. The bar will play each individual chase program at
random. The speed and strobe speed that you have set for each individual chase program will be
used during this show. (see previous description: AUTOMATIC CHASE MODE)
Press the MODE button until
AUTO RUN
is shown on the display.
Press the ENTER button to enter the configuration mode
FQN will start blinking on the display.
Use the DOWN and UP buttons to change the number of times each program should be repeated before
to go automatically to the next automatic program. (01 to 99 times)
Press the ENTER button to confirm
FLOW INVERT
Used to invert the flow direction of the automatic chases. This can be useful when you use several
bars together in master / slave mode
Press the MODE button until
FLOW INVERT
is shown on the display.
Press the ENTER button to enter the configuration mode
Use the DOWN and UP buttons to select ON (flow is inverted) or OFF (flow is not inverted)
Press the ENTER button to confirm
MASTER DIM
This is the general master dimmer for ALL the build-in effect of the 4BAR.
Press the MODE button until
MASTER DIM
is shown on the display.
Press the ENTER button to enter the configuration mode
Use the DOWN and UP buttons to change the general dimmer level of the 4BAR
Press the ENTER button to confirm