JB Systems STRIKER Operation Manual - page 5
ENGLISH
USER MANUAL
JB SYSTEMS
®
3/10
STRIKER
OVERHEAD RIGGING
Important:
The installation must be carried out by qualified service personal only. Improper
installation can result in serious injuries and/or damage to property. Overhead rigging requires
extensive experience! Working load limits should be respected, certified installation materials
should be used, the installed device should be inspected regularly for safety.
Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging
and servicing.
Locate the fixture in a well ventilated spot, far away from any
flammable materials and/or liquids. The fixture must be fixed
at
least 50cm
from surrounding walls.
The device should be installed out of reach of people and outside
areas where persons may walk by or be seated.
Before rigging make sure that the installation area can hold a
minimum point load of 10times the device’s weight.
Always use a certified safety cable that can hold 12 times the
weight of the device when installing the unit. This secondary
safety attachment should be installed in a way that no part of the
installation can drop more than 20cm if the main attachment fails.
The device should be well fixed; a free-swinging mounting is
dangerous and may not be considered!
Don’t cover any ventilation openings as this may result in
overheating.
The operator has to make sure that the safety-relating and
machine-technical installations are approved by an expert before
using them for the first time. The installations should be inspected
every year by a skilled person to be sure that safety is still
optimal.
HOW TO SET UP THE UNIT
FRONT + BACK PANEL:
1. [MIC]:
microphone for sound mode
2. [GAIN]:
trimmer to adjust the sensitivity of the microphone (1) by use of a small screwdriver
3. [MENU]:
press this button to go back to the main menu or to leave submenus.
4. [▼]
button : press this button to go down in the menu
5. [▲]
button : press this button to go up in the menu
6. [ENTER]:
press this button to confirm the selected function in the menu
7. [DISPLAY]:
shows the information on the different modes and functions.
8. [DMX IN]:
3p XLR Male connector to receive DMX data from a console or use in Master/slave mode.
9. M-DMX INPUT:
Please note that this USB-connector is NOT used for updates or to connect the unit to a
PC! Instead this USB-connector makes it very easy to add wireless DMX to the unit! Just add the
(optional) WTR-DMX DONGLE from BRITEQ
®
and you will get wireless DMX! Moreover you will be able
to connect other DMX-controlled equipment to the DMX-output so you can share the wireless DMX
function with all connected units! No extra settings to be made in the setup menu, just follow the