Jbc AD 2200 Instruction Manual - English
4
ENGLISH
Console AC 2600
The console
AC 2600
is designed for modifying the
original regulation program parameters of the following
Advanced control units:
-
AD 2000
soldering station.
-
AD 2200
soldering station.
-
AD 4200
and
AD 4300
dual soldering stations.
-
AR 5500, AR 5800 (*)
and
DS 5300 (*)
desoldering
stations.
-
AM 6000
and
AM 6500 (*)
rework stations.
(*)
These stations need a console whose
program version is 4.0 or higher.
Changes avalaible to perform:
- Fixing the the working temperature.
- Selection of temperature units in Celsius grades
-
°
C- or Fahrenheit -
°
F-.
- Modification of sleep temperatures and standby
times.
- Adjustment of temperature.
- Set the parameters back to the original parameters.
- Read-out data:
Working hours.
Sleep cycles and sleep hours.
Cartridge and iron changes.
Program version.
JBC reserves the right to make technical changes without
prior notification.
Temperature sealing-cover
0261410
Accessory which replaces the
selection temperature button and
it is use to prevent operators
from changing the temperature
that has been pre-selected.
Indicates the selected
temperature.
Alignment
XX
XXXXX
Important.
-
It is essential to insert the cartridge till the end
for a good connection. Take the mark
a s
reference.
Advanced series cartridge
Cartridge is made of the heating element which has the
heating system, temperature sensor and long life tip.
Long-life tip
is basically made of:
1
Copper
2
Iron
3
Chromium
4
Tin plate
Long-life tip care
Except for the copper core, the rest of metals are
placed galvanically on layers relatively thin, so it
is necessary to avoid the reasons which can
cause its destruction.
To clean the tips, use the sponge included with
the stand and check it is slightly moisted.
O n l y d e i o n i s e d w a t e r ( c a r b a t t e r y w a t e r )
should be used in order to wet the sponge. If
normal water was to be used, it is very likely that
the tip will become dirty due to the salts dissolved
within the water.
To re-tin the soldering tips, we recommend using
the tip tinner/cleaner TT 9400 ref. 9400000.
Fume extractor accessories
Specially designed for the Advanced Series
handpieces 2010/2210 and 2045/2245. Easily clips
onto the handpiece and can be quickly removed
for easy maintenance.
For handpieces
2045/2245
:
Standard Ref.0495000
+20mm longer Ref.0455002
For handpieces
2010/2210
Ref.0265000
AC 2600
Ref. 2600000