Jbc jbs-600 User Manual - Introduction
-1-
INTRODUCTION
Your new Jackson Building Centres worktop jig
will more than satisfy your expectations. It has
been manufactured under stringent Quality
Standards to meet superior performance criteria.
CAUTION: Carefully read through this entire
Instruction Manual before using your new jig.
Take special care to heed the warning symbols.
TECHNICAL DATA
Jig thickness
10mm
Cutter size
12.7mm
Workpiece thickness max.
45mm
Worktop width:
min.
600mm
max.
616mm
Guide bush size
30mm
Weight
6.1kg
CONTENTS
TECHNICAL DATA _____________________1
SAFETY ____________________________2-3
ITEMS ENCLOSED ____________________4
DESCRIPTION OF PARTS _______________4
ACCESSORIES
– Recommended Cutters ________________5
– Sub-base Set ________________________5
– Panel Butt Connector Bolts _____________6
– Biscuit Jointer for the Router ____________6
– Flat Biscuit Dowels____________________6
– Clamp ______________________________6
ASSEMBLY
– Location Bush Identification _____________7
– Margin Distance ______________________7
– Setting out the Joints __________________7
OPERATION
– Setting the Length Stop _______________ 8
– Female Joint_________________________8
– Male Joint___________________________9
– Cutting the Bolt Recesses _____________10
– Strengthening the Joint _______________11
– Sealing the Joint ____________________11
SPARE PART ________________________11
MAINTENANCE ______________________11
ENVIRONMENTAL PROTECTION ________11
TROUBLESHOOTING _________________12
GUARANTEE ________________________IB
The following symbols are used throughout this
manual:
Denotes risk of personal injury, loss of
life or damage to the tool in case of non-
observance of the instructions in this
manual.
Refer to the instruction manual of
your power tool.
This unit must not be put into service until it has
been established that the power tool to be
connected to this unit is in compliance with
98/37/EC (identified by the CE marking on the
power tool).
INTENDED USE
This jig is intended for use with a plunge router
with suitable guide bush and router cutter fitted
to rout a kitchen worktop joint in laminate
covered particle board.