Ti-a thermometer for soldering irons www.Jbctools.Com.
Checking the sleep temperature 2 ti-a / thermometer for soldering irons ti-a thermometer 0780476 cable connector manual 1. Connect the ends of the cable to the metal parts of the stand and the handpiece. 2. The soldering tip must be well tinned. 3. Apply solder in the center of the sensor. 4. Wait a...
3 1. Pull out the sensor 2. Adjust at an ambient temperature with slotted screw driver. 3. Wiring like the drawing below. 4. Apply a voltage of 23.65mv and verify the temperature shown in the thermometer is 350°c (662°f) 5. Take note of the deviation to correct future measurements. 6. Insert the sen...
Warranty jbc’s 2 years warranty guarantees this equipment against all manu- facturing defects, covering the replacement of defective parts and all necessary labour. Warranty does not cover product wear due to use or mis-use. In order for the warranty to be valid, equipment must be returned, postage ...
