JBL M2 Owner's Manual - page 5

3

English

Installing the spikes

The M2 is shipped with four rubber feet attached to the bottom of the enclosure for use when the 

speaker is installed upright on a hard surface. Four pointed spikes are included that allow the speaker to 

acoustically decouple from the floor when it is installed upright on a carpeted floor.

WARNING:

 The spikes are extremely sharp. Use caution when handling them. 

If you wish to use the spikes when installing the speaker on a hard surface, place 

coins or similar items under the spikes to prevent damage the floor surface.  

When moving the speaker with the spikes attached, never slide it along the floor, as this can damage the floor, 

the spikes or the speaker itself. Lift the speaker and carry it to its new location.

When using the spikes, do not remove the rubber 

feet from the speaker. To install the spikes, position 

the speaker on a carpeted or padded surface. Insert 

the threaded end of the spike into the aperture of the 

rubber foot. Turn the spike in a clockwise direction and 

continue until the spike is inserted as far as it will go.