P10sw, p12sw performance ™ series owner’s guide ® performance p10/12sw om 10/26/05 9:02 am page 3.
2 read first! Important safety precautions! 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 7. Do not block any ventilation openings. Install in accordance with the manu...
Speaker placement • as a general rule, bass response increases as a subwoofer is placed closer to a wall. Therefore, bass output is maximized when the subwoofer is placed in a corner. • it is also recommended that the subwoofer be positioned along the same wall as the front loudspeakers. Low-frequen...
4 analog receiver/processor – speaker-level connections use this installation method only with an analog receiver/ processor that does not have digital processing or bass management, and also does not have a subwoofer output or a volume-controlled preamp (line-) level output: connect the speaker wir...
Digital receiver/processor – lfe connection use this installation method for dolby digital, dts ® or other digital surround processors that have bass-management programming, or for analog receivers/processors that have a filtered subwoofer output: important: make sure that the lfe toggle switch on t...
Operation when the unit is plugged in and the power switch is on and no signal is received, the led on the amplifier panel will turn red. When a signal is present, the led will turn green. Note: it will take several min- utes for the led to turn from green to red after the input signal to the subwoo...
Troubleshooting if you used the high-level (speaker) inputs and there is no sound from any of the speakers: • check that the receiver/ amplifier is on and a source is playing. • check that the powered subwoofer is plugged into an active electrical outlet and is switched on. • check all wires and con...
Specifications p10sw p12sw peak dynamic power † : 300 watts 500 watts amplifier power (rms): 150 watts 250 watts driver: 10" polyplas ™ 12" polyplas ™ inputs: line-level (switchable to lfe) line-level (switchable to lfe) and speaker-level with and speaker-level with 5-way binding posts 5-way binding...
