Jcb JCB-AG720 Safety And Operating Manual - Rotating The Gear Case

JCB, SO53 3LE

www.JCBDIY.com

Customer Helpline 0333 0143092  

at an angle of 30° to 40°. Move 

the machine back and forth with 

moderate pressure. In this manner, 

the workpiece will not become too 

hot, does not discolour and no 

grooves are formed.

WARNING! Never use a 

cutting disc for roughing.

3. CUTTING

WARNING! For cutting metal, 

always work with the wheel 

guard for cutting.

When cutting, do not press, tilt or 

oscillate the machine. Work with 

moderate feed, adapted to the 

material being cut.

Do not reduce the speed of running 

down cutting discs by applying 

sideward pressure.

The direction in which the cutting is 

performed is important.

The machine must always work in 

an up-grinding motion. Therefore, 

never move the machine in the 

other direction! Otherwise, the 

danger exists of it being pushed 

uncontrolled out of the cut.

ROTATING THE GEAR CASE

Before any work on the machine 

itself, pull the mains plug, and 

then remove the disc and guard.

The gear case can be rotated with 

respect to the machine housing. In 

this manner, the On/Off switch can