Jcb JCB-AG720 Safety And Operating Manual - Further Safety Instructions
JCB, SO53 3LE
www.JCBDIY.com
Customer Helpline 0333 0143092
by various operations. The dust
mask or respirator must be
capable of filtrating particles
generated by your operation.
Prolonged exposure to high
intensity noise may cause hearing
loss.
9. Keep bystanders a safe
distance away from work
area. Anyone entering the
work area must wear personal
protective equipment. Fragments
of workpiece or of a broken
accessory may fly away and cause
injury beyond immediate area of
operation.
10. Hold power tool by insulated
gripping surfaces only, when
performing an operation where
the cutting accessory may
contact hidden wiring or its own
cord. Cutting accessory contacting
a "live" wire may make exposed
metal parts of the power tool "live"
and result in operator injury.
11. Position the cord clear of the
spinning accessory. If you lose
control, the cord may be cut or
snagged and your hand or arm
may be pulled into the spinning
accessory.
12. Never lay the power tool down
until the accessory has come to
a complete stop. The spinning
accessory may grab the surface
and pull the power tool out of your
control.
13. Do not run the power
tool while carrying it at your
side. Accidental contact with
the spinning accessory could
snag your clothing, pulling the
accessory into your body.
14. Regularly clean the power
tool’s air vents. The motor’s
fan will draw the dust inside
the housing and excessive
accumulation of powdered metal
may cause electrical hazards.
15. Do not operate the power tool
near flammable materials. Sparks
could ignite these materials.
16. Do not use accessories that
require liquid coolants. Using
water or other liquid coolants may
result in electrocution or shock.
17. Your hand must hold on the
handle when you are working.
Always use the auxiliary handles
supplied with the tool. Loss of
control can cause personal injury
Further safety instructions
for all operations
Kickback and Related
Warnings
Kickback is a sudden reaction to a
pinched or snagged rotating disc,
backing pad, brush or any other
accessory. Pinching or snagging
causes rapid stalling of the rotating
accessory which in turn causes
the uncontrolled power tool to be
forced in the direction opposite
of the accessory’s rotation at the