Jcb JCB-BS950 Safety And Operating Manual - 7. Dust Bag (See F)

JCB, SO53 3LE

www.JCBDIY.com

Customer Helpline 0333 0143092  

adjustment knob counter-clockwise 

and clockwise if belt runs inward 

(See E). Adjust the belt until the 

outer edge of the belt is even 

with the outer edge of the base-

plate (13). Belt life will be greatly 

increased by keeping the tracking 

adjustment set properly.

7. DUST BAG (See F)

You must use the dust collection 

bag provided to collect the dust 

produced during sanding. The dust 

collection bag plastic bracket slides 

down onto the dust outlet on the belt 

sander. When the dust collection 

bag is full, remove and empty by 

opening the zip on the dust bag (4).

8. DRIVE BELT 

REPLACEMENT(See G)

WARNING! Remove the 

main plug from the socket 

before carrying out a drive belt 

replacement. Remove the three 

screws (a) and the belt cover as 

shown. Carefully cut the drive belt if 

not already broken and remove from 

your belt sander. Fit your new drive 

belt around the large pulley. Then 

install onto the small pulley by 

rotating clockwise and pushing the 

drive belt shown around the small 

pulley at the same time. The drive 

belt will be a tight fit. Fit the belt 

cover and three screws.

E

13

6

F

4

5

a

G