Jcb JCB-CD18Li Safety And Operating Manual - Problem Solving
SO53 3LE
Customer Helpline 0845 600 5526
PROBLEM SOLvIng
1. wHy DOES tHE DRILL nOt tuRn On wHEn yOu PRESS tHE
SwItCH?
The forward/reverse rotation control, which is on top of the trigger, is positioned in the
lock function. Unlock the forward/reverse rotation control by putting it into the required
rotation position. Push the trigger and the drill will start to rotate.
2. tHE DRILL StOPS BEfORE tHE SCREw IS COMPLEtELy
tIgHtEnED. wHy?
Verify the torque position of the torque adjusting ring, you can find the torque-adjusting
ring between the chuck and the drill body. Position 1 is the lowest torque (screw driving
force) and position 20 is the highest torque (screw driving force). Position 21 is for drill
operation. Regulate the torque adjusting ring to a higher position to reach the best
result.
3. REaSOnS fOR DIffEREnt BattERy PaCK wORKIng tIMES
Charging time problems, as above, and having not used a battery pack for a
prolonged time will reduce the battery pack working time. This can be corrected after
several charge and discharge operations by charging & working with your drill. Heavy
working conditions such as large screws into hard wood will use up the battery pack
energy faster than lighter working conditions. Do not re-charge your battery pack
below 0
o
C and above 45
o
C as this will affect performance.
MaIntEnanCE
Your tool requires no additional lubrication or maintenance.
There are no user serviceable parts in your power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean with a dry cloth. Always store your power
tool in a dry place. Keep the motor ventilation slots clean. Keep all working controls
free of dust. Occasionally you may see sparks through the ventilation slots. This is
normal and will not damage your power tool.