Jcb JS710LE Safety And Operating Manual - 11. Dust Tube (See J)

JCB, SO53 3LE

www.JCBDIY.com

Customer Helpline 0333 0143092  

base plate and angle plate (8) 

superposition at the desired angle 

(0, 15, 30, 45) (See I). For other mitre 

angles, rotate to your desired angle 

(use a protractor scale). Following 

one of the above procedures, hold 

the base plate in position and firmly 

tighten the bolts to clamp the base 

plate at that angle. Finally, check the 

angle and ensure the base plate is 

firmly clamped. The angle markings 

on the base plate are accurate for 

most general purposes but it is 

recommended for accurate work to 

set the angle with a protractor and 

make a test cut on other material. 

11. DUST TUBE (See J)

Mount the dust tube (6) into the 

opening of the base plate (7). 

Make sure that the plastic tip of the 

vacuum connection engages into 

the corresponding opening on the 

housing as shown in the figure. 

12. PROTECTION FINGER 

WIRE

The finger wire is located in front of 

the blade holder. Whilst working, it 

will help prevent accidental contact 

with moving blade.

1

3. DUST BLOWER AIR 

HOLE

This is a small aperture located 

underneath the housing just behind 

the blade guide. Ensure this is 

kept clean to allow the air flow to

H

8

I

8

7

6

J