JCG JHR-N916R User Manual - 2.2 System Requirements
www.jcgcom.com
12
6.USB 2.0
Connect to USB device, such as USB hard disk, USB thumb driver or USB printer
7.WAN (Internet) port
WAN port
8.LAN 1-4 network interface
LAN port
9.Power jack (DC IN)
Connect to power adapter
10.RST/WPS button
When the router is working, press this button for 1 second to start WPS progress; press this
button for 5 seconds and the system will restore to factory settings.
2.2 System Requirements
Browser: Internet Explorer 6.0+, Firefox 2.0+, Opera 10.0+ and Safari 5.0+;
Operating system: Windows XP and above, Linux 2.4+, Mac OS X, iOS 4.0+ and Android
2.0+;
Broadband service or broadband access point;
Network Interface Card
Standard Ethernet cable
2.3 Installation Environment
Keep the router horizontal
Adjust the angle of the antenna to a suitable direction
Avoid placing the router near any heat source
Avoid placing the router in a humid environment
2.4 Hardware Installation Steps
1.Use the provided power adapter to connect to the router.
2.Use Ethernet cable to connect the broadband access point and the WAN port of the
router.
3.For wired connection, use Ethernet cable to connect the computer and the LAN port of
the router.