JCG JHR-N916R User Manual - page 14
www.jcgcom.com
13
4. For wireless connection, please check whether the WIFI is enabled, scan and connect
to the in accordance with the wireless network name (SSID) with the key on the back of the
router.
Chapter III Router Setup
Correct setup on the router is required before using it normally. Here is the specific
guidance on how to carry out installation and set up the router.
3.1Set up Network Correctly (take Windows 7 as an example)
This step can be skipped if no special setup was done on your computer.
1) Click:" Start->Control Panel->Network and Internet->Network and Sharing Center-
>Change adapter settings->Local Area Connection” and select the connected network
card. Then right click “Local Area Connection” to select Properties
2) Select
Internet Protocol Version 4(TCP/IPv4)and click Properties