JDM TP-100RDS Installation & Operation - page 2
JDM
®
AM-FM RDS Tuner Receiver Module
2
FEATURES
• Digital display analogue tuner AM/FM bands.
• Radio Data System (RDS) function for FM radio.
• 30 station preset memories (FM:18; AM:12).
• Manual or Scan (Seek) tuning, up and down.
IN THE BOX
• AM/FM RDS Radio Tuner module.
• Antenna terminal module – to insert into the PA amplifier rear
panel and allow AM and FM antenna wires to be connected.
• 300 ohm balanced FM antenna cable.
• Screws to attach module to PA system.
SUITABLE FOR:
This module is designed to be used as an accessory to the JDM
PA amplifier products:
JDM ZA-6120 (Altronics code: A 4330)
JDM ZA-6240 (Altronics code: A 4332)
JDM ZA-6480 (Altronics code: A 4336)
JDM TA-1060 (Altronics code: A 4320)
JDM TA-1120 (Altronics code: A 4322)
JDM TA-1240 (Altronics code: A 4324)
INTERNAL CONNECTIONS:
Before commencing installation, familiarise yourself with the
location of the Antenna and Power/Signal headers as shown in
Figure 1.
Figure 1: Location of antenna and power/signal headers.
ANTENNA
POWER/SIGNAL
INSTALLATION INSTRUCTIONS A 4330 - A 4336
JDM ʻZAʼ SERIES AMPLIFIERS
Warning: Before commencing installation ensure amplifier is
disconnected from power socket.
Step 1: Open the cover of the amplifier and unscrew the blank
panel located on the front of the amplifier.
Step 2: Locate the punchout panel marked “FM 75Ω” on the
rear panel and remove it. You may need to cut the panel sup-
ports with some heavy duty cutters or a small saw.
Step 4: Insert module into amplifier and screw to front panel.
Ensure the plastic locating pegs on the module panel fit into the
amplifier front panel correctly. See photo:
Step 3: A fly lead and header will be taped to the back of the
front blank panel. Remove the tape and connect this lead to the
Power/Signal header on the tuner module. See photo: