JDM TP-100RDS Installation & Operation - page 3
JDM
®
AM-FM RDS Tuner Receiver Module
3
Step 5: Connect antenna module to the antenna header in the
main tuner module. See photo:
Step 6: Attach the antenna module to the rear panel using the
self tapping screws provided.
Step 7: Connect antenna to antenna module on rear panel. See
figure 3 and 4 for examples of FM and AM antenna wiring.
INSTALLATION INSTRUCTIONS A 4320 - A 4324
JDM ʻTAʼ SERIES AMPLIFIERS
Warning: Before commencing installation ensure amplifier is
disconnected from power socket.
Step 1: Open the cover of the amplifier and unscrew the blank
panel located on the front of the amplifier.
Step 2: Locate the punchout panel marked “FM 75Ω” on the
rear panel and remove it. You may need to cut the panel sup-
ports with some heavy duty cutters or a small saw.
Step 3: A fly lead and header will be taped to the back of the
front blank panel. Remove the tape and connect this lead to the
Power/Signal header on the tuner module. See photo:
Step 4: Insert module into amplifier and screw to front panel.
Ensure the plastic locating pegs on the module panel fit into the
amplifier front panel correctly. See photo:
Step 5: Connect antenna module to the antenna header in the
main tuner module. See photo:
Step 6: Attach the antenna module to the rear panel using the
self tapping screws provided.
Step 7: Connect antenna to antenna module on rear panel. See
figure 3 and 4 for examples of FM and AM antenna wiring.