JDS Uniphase P5000i User Manual - page 18
USER MANUAL
18
Optical Settings
• StandardTips(withBAP1)
Select when using standard tips with FBPP-BAP1 barrel assembly. Tips that use this
setting include FBPT-SC, FBPT-LC, FBPT-ST, FBPT-FC, FBPT-SC-APC & FBPT-FC-APC.
• StandardTips(withBAP2)
Select when using standard tips with the FBPP-BAP2 barrel assembly for longer
reach inspection. Note: The FBPP-BAP2 accepts the same tips as the FBPP-BAP1.
• Mil/AeroTips&Guides(withBAP3)
Select when using guides designated for inspecting Military & Aerospace
connectors with the narrow barrel assembly (FBPP-BAP3).
• LongReach(-L)Tips
Select when using long reach inspection tips. Note: Long Reach inspection tips are
noted with the suffix “-L” on the part number (ex: FBPT-SC-L, FBPT-LC-L, etc.).
• RibbonTips
Select when using tips designated for inspecting ribbon connectors. Note: Ribbon
connectors contain an array of multiple fibers in a single connector (ex: FBPT-MTP).
• E2000Tips
Select when using long reach E2000 inspection tips (ex: FBPT-E2000).
• SC-A6Tip(60DegreeAngle)
Select when using SC inspection tips with a 60 degree angle. Note: Angled
inspection tips are typically noted with the suffix “-A6” on the part number (ex: FBPT-
SC-A6, FBPT-SCA-A6).
NOTE:
Users can also create new Optical Settings for specialty tips or applications. See the
FiberChekPRO user manual for details.
Optical Settings configure the P5000i for optimal performance with a given
tip. Users can select the best optical settings for the type of inspection tip that
is attached to their probe. The P5000i comes pre-configured with the following
optical settings:
CHAPTER 3
P5000i Digital Analysis Microscope