Jedia L3.0 Operating Instructions Manual - page 3
SAFETY INSTRUCTIONS
안 전 사 항
제품을 운용하기전에 모든 안전사항을 읽어 보십시오.
1. 이런 장소에 설치하여 주십시오.
진동이나 경사가 심하지 않고 바닥이 평평한 장소.
통풍이 잘되고 물기나 습기가 많지 않은 장소.
직사광선을 받지 않는 장소 또는 난방기구(발열체)에서 멀리 떨어진 장소.
인화성 물질(화학약품)이 없는 장소.
2. 설치시 이런점을 주의하십시오.
사용설명서 시스템 연결방법을 완전히 읽으신 후에 연결해 주십시오.
각종 연결선을 완전하게 연결해 주십시오.
(주전원 코드를 뽑은 상태에서 연결.)
불완전한 연결은 잡음, 제품의 손상 또는 안전사고의 원인이 됩니다.
전기적 충격 또는 감전사고의 위험이 있으므로 뚜껑을 열지 말아주십시오.
주 교류 전원 플러그를 연결하기 전에 사용전압을 확인하신 후 안전하게
연결하십시오.
제품을 수리시는 규정된 부품과 자격이 있는 사람이 수리를 하여야 함.
1
FEATURES
특
징
AUTOMATIC VARIABLE SPEED FAN
Values shown are for converted chip
levels to within 100W based on actual
measurement data for each amplifier.
New model L-Series are high efficiency
amplifiers with new special design.
New L-Series high power amplifiers make
more efficient use of the AC power more
than conventional amplifier technology.
Also new EIC (electronic Improved Circuit)
engine consumes power efficiency, which
allows the amplifier to produce the same
amount of output power with about half the
input power required and heat loss about
⅓
comparing that of conventional amplifiers.
온도에 따라 팬 속도 자동조절
OVER CURRENT PROTECTION
과전류 보호회로
OVER HEATING PROTECTION
과열 보호회로
OVER LOARD PROTECTION
과부하 보호회로
IN RUSH CURRENT PROTECTION
전원 공급 지연회로
PEAK CLIPPING LIMITER CIRCUIT
피크 클리핑 리미터 회로
OUTPUT LED METER PER CHANNEL
출력 LED 레벨 메터
STEREO BRIDGED MONO, PARALLEL MODE
스테레오 모노, 병렬 운용 방식
VARIABLE LOW CUT FILTER(10Hz~200Hz)
연속 가변형 저역차단 필터
VARIABLE SUB WOOFER FILTER(50Hz~160Hz)
연속 가변형 저음 스피커용 필터
VARIABLE CROSSOVER(X-OVER) FILTER(50Hz~2.5Hz)
연속 가변형 크로스오버 필터
그래프의 값은 각 앰프의 실제측정 데이터
를 근거로 하여 100W 범위 내로 치환한
값이다.
제디아의 NEW MODEL인 POWER AMP L시리즈는 고효율 POWER AMP로
서 새로운 타입의 디자인이다. 전형적인 리니어 앰프에 비해 소비 전력은
반에 불과하고 발열량도 ⅓수준이다. 이 기술은 제디아의 진보된 기술이
만들어낸 EIC(EFFICIENCY IMPROVED CIRCUITRY) 문이다.
NEW CIRCUIT기술로 인하여 AMP파워 섹션이 작아지게되었고 열 손실도
줄었다. 기존 디자인보다 작고 가벼운 AMP를 만들 수 있게되었다.
Ideal Ratio
EIC 기술은 음질에 전혀 영향을 주지않고 보조 전원 공급 기인 아날로그
콘트롤에 의해 주 전원공급 기인 디지탈 방식으로 전원 공급을 하므로
효율 증대를 가져온다.
The EIC engine outperforms other
efficiency-enhancing schemes without
degrading sound quality by digital power
supply.
This apparatus should be serviced by qualified service person.
Read all safety instruction before operating the L-Series amplifiers.
1. Install equipment as follow conditions.
Install at the place, not bending curved.
Do not install this apparatus in a confined space such as a book
case or similar unit.
The apparatus shall not be exposed to dripping or splashing and
no object filled with liquids, such as vases, shall be place on the
apparatus.
Locate this apparatus away from heat source, such as radiators
or other device that produce heat.
Do not drop objects or spill liquids into the inside of the apparatus.
2. Keep in mind the following when connecting the apparatus.
To prevent electric shock, do not open top cover.
Connect the power cord with safety after check of AC power.
Connect the apparatus after reading of O/P manuals.
Connect each connection of the apparatus perfectly, If not, It maybe
caused hum, damage, electric shock in case of mis-connecting.