Jedia L3.0 Operating Instructions Manual - page 8
시스템 연결그림은 일반적인 설치 방법으로 다음사항을 주의 하십시오.
1. 스피커 라인 연결시 앰프의 전원 스위치를 꺼주십시오.
2. 스피커 결선은 결선도를 참고하여 주십시오.
3. 앰프는 3개의 모드(스테레오, 브릿지 모노, 병렬)로 전환 시킬 수 있으며,
4. 잘못된 결선은 스피커에 치명적인 손상을 초래합니다.
앰프가 동작 중일때는 전환하지 마십시오.
스테레오 방식
결선 하십시오.
모드 스위치를 스테레오 쪽으로 전환하고 스피커 극성에 주의하여
Wiring the following instructions describe the most common
ways to install your amplifier into a sound system.
1. First, turn off power switch befor connection.
2. Refer to wirning diagram for speaker connection.
(stereo, bridge-mono, Parallel)
3. L series amplifier maybe operated in one of three modes
4. JEDIA assumes no liability for damaged loads resulting from
careless amplifier use or deliberate over powering.
How to connect stereo(2-CHANNEL) MODE
connect the output wiring as shown.
To put the amplifier into stereo mode, first turn the amplifier off,
then slide the stereo-mono switch toward the left, and properly
C
ONNECTIONS (설치방법)
6
AMP MODE
B
G
A
INPUT
CH-A
ON
CH-B
Stereo
Bridged
Parallel
Stereo
CH-B
CH-A
CH-B
CH-A
CLIP/LIM
Parallel
Bridged
B/D
B/D
LIFT OFF
GROUND ON
1500W PER CH at 4ohms
AC 230V
/50Hz
4210W
MODEL NO:. L 6.0
STEREO POWER AMPLIFIER
MADE IN KOREA
STEREO
PROFESSIONAL AUDIO MIXER 8.4.4.2
TRIPAC Series or
STAGE PRO MIXER
TRIPAC