Jeep Cherokee 1993 Maintenance Information - page 9
Front Axle (Model 30)
Command-Trac (Disconnect) ............... 3.76 Pts. (1.65L)
(Disconnect Housing) (8) ............... 5.0 Ozs. (0.15L)
Selec-Trac (Non-Disconnect) .............. 3.13 Pts. (1.5L)
Rear Axle
1989-94 (9) ............................... 2.5 Pts. (1.2L)
1995-96
Model 35 (9) ............................ 3.5 Pts. (1.6L)
8-1/4" (9) .............................. 4.4 Pts. (2.1L)
(1) - Capacities are recommended or calculated levels. Always use
dipstick (if available) to measure level.
(2) - Use of R-12 in a R-134a system will result in SEVERE DAMAGE
(3) - Total quantity required will vary, after adding amount shown
check dipstick and fill to proper level.
(4) - Includes 2.3 qts. (2.2L) for coolant recovery bottle.
(5) - Includes 1.0 qt. (0.9L) for coolant recovery bottle.
(6) - Includes Filter.
(7) - Fill to bottom edge of filler plug hole.
(8) - Add 5 ozs. of gear lubricant through indicator switch hole.
(9) - If equipped with TRAC-LOK, add 4 ozs. of Limited-Slip
differential lubricant additive first, then add new fluid.
WHEEL & TIRE SPECIFICATIONS
WHEEL & TIRE SPECIFICATIONS TABLE
Wheel Size Tire Size
Cherokee
15x6 & 15x7 (Aluminum Or Steel) ............. P195/75R15
15x6 & 15x7 (Aluminum Or Steel) ............. P205/75R15
15x6 & 15x7 (Aluminum Or Steel) ............. P215/75R15
15x6 & 15x7 (Aluminum Or Steel) ............. P225/75R15
Wagoneer
15x6 (Aluminum/Steel) ....................... P205/75R15
All Models
16-Inch Wheels ...................... Compact Spare Tire
TIRE REPLACEMENT
CAUTION: Always ensure all 4 tires on the vehicle are the same size,
except when using the temporary spare. The use of
mismatched tires may cause unpredictable handling.
Replacing original tires with tires of a different size may
result in false speedometer and odometer indications.
TIRE INFLATION
The tire specification decal is located in the glove box.
WHEEL TIGHTENING
Tighten the lug nuts firmly in a crisscross pattern as shown
in Fig. 6. Tighten per following specifications. Always position wheel
locking nut opposite valve stem in position indicated. See Fig. 6.
1989-92
Tighten lug nuts in crisscross pattern to 80-110 ft. lbs.
(109-150 N.m).