Jeep XJ Manual - page 19
(3) Turn the bulb holder counterclockwise about
sixty degrees on the cluster electronic circuit board.
(4) Pull the bulb and bulb holder unit straight
back to remove it from the bulb mounting hole in the
cluster electronic circuit board (Fig. 13).
CLUSTER LENS
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the instrument cluster from the instru-
ment panel. Refer to Instrument Cluster in the
Removal and Installation section of this group for the
procedures.
(3) Work around the perimeter of the cluster hous-
ing to disengage each of the latches that secure the
cluster lens to the cluster housing (Fig. 14).
(4) Gently pull the cluster lens away from the clus-
ter housing.
ODOMETER RESET KNOB BOOT
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the instrument cluster from the instru-
ment panel. Refer to Instrument Cluster in the
Removal and Installation section of this group for the
procedures.
(3) Remove the cluster lens from the cluster hous-
ing. Refer to Instrument Cluster Components -
Cluster Lens in the Removal and Installation sec-
tion of this group for the procedures.
(4) Remove the odometer reset knob boot by pull-
ing it out of the cluster lens.
CLUSTER HOOD AND MASK
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the instrument cluster from the instru-
ment panel. Refer to Instrument Cluster in the
Removal and Installation section of this group for the
procedures.
(3) Remove the cluster lens from the cluster hous-
ing. Refer to Instrument Cluster Components -
Cluster Lens in the Removal and Installation sec-
tion of this group for the procedures.
Fig. 13 Cluster Bulb Locations
Fig. 14 Instrument Cluster Components
XJ
INSTRUMENT PANEL SYSTEMS
8E - 19
REMOVAL AND INSTALLATION (Continued)