Jeep XJ Manual - page 22
(6) Install the cluster bezel onto the instrument
panel. Refer to Cluster Bezel in the Removal and
Installation section of this group for the procedures.
(7) Reconnect the battery negative cable.
GLOVE BOX
WARNING: ON VEHICLES EQUIPPED WITH AIR-
BAGS,
REFER
TO
GROUP
8M
-
PASSIVE
RESTRAINT SYSTEMS BEFORE ATTEMPTING ANY
STEERING
WHEEL,
STEERING
COLUMN,
OR
INSTRUMENT PANEL COMPONENT DIAGNOSIS OR
SERVICE. FAILURE TO TAKE THE PROPER PRE-
CAUTIONS COULD RESULT IN ACCIDENTAL AIR-
BAG DEPLOYMENT AND POSSIBLE PERSONAL
INJURY.
ROLL DOWN
(1) Disconnect and isolate the battery negative
cable.
(2) Open the glove box.
(3) Locate the two rubber stop bumpers on the
upper edge of the instrument panel glove box open-
ing (Fig. 16).
(4) Remove the two glove box stop bumpers by
sliding them downward and out of the slots in the
instrument panel upper glove box opening reinforce-
ment.
(5) Roll the glove box downward so that the stops
molded into the glove box bin pass through the stop
bumper slots in the instrument panel upper glove
box opening reinforcement.
(6) Reverse the roll down procedure to roll the
glove box back up into the instrument panel.
REMOVAL
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the three screws that secure the glove
box hinge to the instrument panel lower glove box
opening reinforcement (Fig. 17).
(3) Release the glove box latch.
(4) Remove the glove box from the instrument
panel.
INSTALLATION
(1) Position the glove box to the instrument panel
with the bin inserted in the glove box opening far
enough so that the stops on each side of the glove
box bin are located behind the rubber stop bumpers
located on the instrument panel upper glove box
opening reinforcement.
(2) Align the screw holes in the glove box hinge
with the mounting holes in the instrument panel
lower glove box opening reinforcement.
(3) Install and tighten the three screws that secure
the glove box hinge to the instrument panel lower
glove box opening reinforcement. Tighten the screws
to 2.2 N·m (20 in. lbs.).
(4) Reconnect the battery negative cable.
GLOVE BOX COMPONENTS
The glove box hinge, bin, inner door and latch are
serviced only as a complete unit. The glove box outer
door and lock cylinder are serviced separately.
WARNING: ON VEHICLES EQUIPPED WITH AIR-
BAGS,
REFER
TO
GROUP
8M
-
PASSIVE
RESTRAINT SYSTEMS BEFORE ATTEMPTING ANY
STEERING
WHEEL,
STEERING
COLUMN,
OR
INSTRUMENT PANEL COMPONENT DIAGNOSIS OR
SERVICE. FAILURE TO TAKE THE PROPER PRE-
CAUTIONS COULD RESULT IN ACCIDENTAL AIR-
BAG DEPLOYMENT AND POSSIBLE PERSONAL
INJURY.
Fig. 16 Glove Box Stop Bumpers Remove/Install
Fig. 17 Glove Box Remove/Install
8E - 22
INSTRUMENT PANEL SYSTEMS
XJ
REMOVAL AND INSTALLATION (Continued)