JEI MAGBEAST 2 Safety Instructions And Operator's Manual - page 5
JEI SOLUTIONS LTD
MAGBEAST 2
Operator’s manual for Drilling Machine
MAGBEAST 2
- 4 -
Safety chain can also secure the drill through
the handle
.
10) Do not touch the spindle and cutter during work.
11) Tools must be fastened firmly. When a milling cutter is used, check before start of work
if tool holding screws are screwed tight.
12) It is not permitted to use blunt of damaged tools.
13) Do not use milling cutter without pilots, and arbors without ejection spring.
Do not touch or replace the tool with power source on
– while
electromagnetic base is being used.
14) Use tools recommended
in Operator’s Manual only.
15) After use, always clean drilling machine from metal chips and coolant.
16) Always unplug machine from power supply during any work on the machine.
17) In the case that the machine falls on a hard surface, from a height, is wet or is
subjected to other unfortunate events that could affect its technical state - work should
be terminated immediately and the machine should be sent to service for inspection as
soon as possible.
Drawing 1.
Examples how safety chain should be fastened.
.