JEI MAGBEAST 2 Safety Instructions And Operator's Manual - 2. Machine Start Up
JEI SOLUTIONS LTD
MAGBEAST 2
Operator’s manual for Drilling Machine
MAGBEAST 2
- 8 -
2. Machine start up
The machine is supplied in a metal box with complete standard equipment.
MAGBEAST 2 comes in a standard equipment set which consists of:
metal box
1pc
drilling machine
1pc
arbor AMT2-C-19/2-2
1pc
cooling system
1pc
chip guard
1pc
spoke handles
3pcs
hex wrench s=4
1pc
hex wrench s=5
1pc
wedge, MT2
1pc
safety chain with snap hook
1pc
operator’s manual
1pc
2.1 Before first drill:
Steel elements of the drilling machine are protected for transit and storing with grease
film. Before first start up of the machine all grease should be removed
Before each use all handles should be screwed into pinion.
2.2 Before you cut
Before positioning the machine on work piece always make sure that:
-
Work piece is made of ferromagnetic steel (some grades of stainless or acid
resistant steel does not conduct magnetic flux)
-
thickness of work piece is at least 3/8” (10 mm)
-
surface of steel under the magnet is flat
-
wipe, brush or sand down clean surface where you intended to place the drilling
machine, so that you remove rust, paint, dirt etc which would reduce adhesive power of the
electromagnetic base.
Install drill bit, milling cutter or other tooling such as tap or reamer in the machine before
plugging it into mains. Then plug it in (see paragraph 2) and position where you wish to use
it. Place the machine so that the tool is over the centre of the hole you intend to make and
turn the magnetic base ON.
Prior to use always make sure that the machine is secured from falling
down with original
chain (as described in paragraph I no.2 “Important rules of
safe use of drilling machine
”).