JEM ZR44 Hi-Mass User Manual - page 13
Fog fluid types
13
Fog fluid types
The following types of Martin/Jem fog fluid are suitable for use in this machine.
Each produces a different effect as described below. Martin supplies high
quality fog fluids that are based on ultra-pure deionized water. Use only the
following genuine Martin/Jem fog fluids. No other fluid is suitable for use.
DANGER! The smoke machine can run safely only on the specific smoke fluids it
is designed for. Use ONLY the Martin/Jem smoke fluids designated in this
manual. NEVER use any other type of fluid, or toxic gas may be produced. You
will probably also cause damage to the system that is not covered by the product
warranty. Do not dilute smoke fluid with water or any other liquid. Discard smoke
fluid if it becomes contaminated.
R e g u l a r D J F l u i d ( D J m i x )
Regular DJ fluid is an economical fluid that gives a good, medium density
smoke well-suited for atmospheric effects.
P r o S m o k e S u p e r ( Z R m i x )
Pro Smoke Super fluid is a high-quality, general purpose fluid that produces a
dense white airborne fog with medium dispersal time. Its medium to high index
of refraction permits both good atmospheric effects and denser “white-outs”.
P r o S m o k e H i g h D e n s i t y ( S P m i x )
Pro Smoke High Density fluid generates a high density, white, airborne fog with
a very high index of refraction and slow evaporation rate. It is well suited for
scenic obscuring, dramatic strobe effects, and “white-outs”.
P r o S m o k e S t u d i o ( D X m i x )
In a studio or theater environment, a lighter, faster dispersing fog is often
preferred. Pro-Smoke Studio offers a less dense environment to Pro-Smoke
Super and is therefore less likely to interfere with TV camera focusing.
i - f o g
i-fog is not only kind to your lights, but is also more economical to use thanks to
its incredible long “hang time” characteristics. In environments unaffected by
extraction and air-conditioning, i-fog can be expected to last
P r o S t e a m S i m u l a t i o n
Steam simulation fluid specifically designed for ‘steam’ effects. Creates a white
burst, but is fast dispersing.
(In order to optimise the machines temperature setting the dip switch on the
rear marked ‘Low Temp’ should be set down to position 1).