Jenn-Air CVEX4100 Series Installation Instructions Manual - page 2
2
Instructions For Installer:
S
Save installation instructions for local inspector’s use.
S
Leave installation instructions with the appliance.
S
Refer to
“Installer Installation Suggestions”
on page 3 before cutting.
S
Dimensions shown in both inches and centimeters.
S
Consult ducting guide for proper instruction.
S
Dimensions “A”
&
“B”
- tolerances +/-1/16
²
or +/-.16 cm.
S
Dimension “J”
- provide 2
²
min. (5.08 cm) cabinet clearance to motor for cooling purpose.
NOTE:
Where possible, 6
²
(15.24 cm) is recommended for motor blower service.
S
Dimension “K”
- provide 6-1/4
²
(15.88 cm) required for removal of (supplied) grease container(s).
Installed dimension for (supplied) grease container(s) is 5-1/2
²
(13.97 cm).
S
Side Clearance
- grills installed near a side wall must allow a minimum clearance of 6
²
(15.24 cm) between cooktop
and sidewall for maximum performance. Minimum clearance of 1
²
(2.54 cm) is required to sidewalls and 3/4
²
(1.905 cm) to rear wall.
S
Electrical Hookup
- the unit must be properly circuit protected and wired according to local electrical codes. See
electrical wiring information on page 3. Unit power requirements are located on the serial plate.
SINGLE
See side clearance
note below.
Min.
Clearance
Required
17
1/2
²
44.46 cm
12
1/2
²
31.76 cm
4
3/4
²
12.01 cm
Grease
Container
SEE NOTE
BELOW
SEE NOTE
BELOW
DOUBLE
See side clearance
note below.
Min.
Clearance
Required
17
1/2
²
44.46 cm
11
7/16
²
29.06 cm
12
1/2
²
31.76 cm
SEE NOTE
BELOW
SEE NOTE
BELOW
4
3/4
²
12.01 cm
TRIPLE
SEE NOTE
BELOW
SEE NOTE
BELOW
4
3/4
²
12.01 cm
11
7/16
²
29.06 cm
Min.
Clearance
Required
17
1/2
²
44.46 cm
See side clearance
note below.
30
1/8
²
76.52 cm