Jenn-Air JMC2430DS Installation Instructions Manual - Warning
5
Make Electrical Connection
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Use 12 gauge solid copper wire.
Electrically ground oven.
Failure to follow these instructions can result in death,
fire, or electrical shock.
The microwave oven is manufactured with a neutral (white)
power supply wire and a cabinet-connected green (or bare)
ground wire.
1. Disconnect power.
2. Feed the flexible conduit from the microwave oven through
the opening in the cabinet.
3. Remove junction box cover if it is present.
4. Install a UL-listed or CSA-approved conduit connector
to the junction box.
5. Route the flexible conduit from the microwave oven to the
junction box through a UL-listed or CSA-approved conduit
connector.
6. Tighten screws on conduit connector.
7. Complete electrical connection.
A. UL-listed or CSA-approved conduit connector
3-Wire Cable with Ground from Home Power Supply
to Microwave Oven Cable with 4 Wires
1. Connect the 2 black wires (G) together using a UL-listed wire
connector.
2. Connect the 2 white wires (C) using a UL-listed wire
connector.
3. Connect the 2 red wires (F) together using a UL-listed wire
connector.
4. Connect the 2 green (or bare) wires (B) together using a
UL-listed wire connector.
5. Install junction box cover.
A. Cable from home power supply
B. Green (or bare) wires
C. White wires
D. 4-wire cable from microwave oven
E. UL-listed or CSA-approved conduit
connector
F. Red wires
G. Black wires
H. UL-listed wire connector
I. Junction box
B
C
D
H
F
A
G
E
I
A
Install Microwave Oven
1. Using 2 or more people, lift the microwave oven partially
into the cabinet cutout. If a spacer kit has been installed,
lift the microwave oven over it and position the microwave
oven between the guide strips.
A
B
C
C
A. Spacer bar flange
B. Spacer bar
C. Microwave oven