User's manual english overbass ko70 rev.01.
P. 1 user's manual safety instructions this symbol, wherever it appears, alerts you to important operating and maintenance istructions in the accompanying literature. Read the manual! Caution ! • amplifier amplifier amplifier •no naked flame sources such like lighted candles should be placed on the ...
Table of contents 1 introduction p. 03 2 ac power distribution p. 04 3 voltage requirements p. 04 4 p. 04 5 power connector wiring p. 05 6 p. 05 7 amplification & protection circuitry p. 05 8 dsp & remote control p. 06 9 dsp cloner function p. 06 10 power supply & audio section p. 07 11 maintenance ...
1. Introduction p. 3 user's manual k-array is the new voice that sings aloud, "outside the chorus", and whose performance is better than any other products. Born on-the-road, in the pa world, where you get no discount, you have to give your best as fast as you can, often with a "compressed" budget, ...
All amplifier modules and the rest of the audio equipment connected to it (mixing consoles, processors, etc.) must be connected to the ac power distribution in a proper way, preserving ac line polarity and connecting earth ground such that all grounding points are connected to a single node or commo...
The ko70 requires a grounded outlet. It is very important that the system be properly grounded for both safety and proper operation. Use the following wiring diagram to create power cables and distribution systems. 5. Power connector wiring conventions p. 5 user's manual the ko70 require a ground co...
The ko70 have a powerful dsp that manages all the functions of the speakers. Each system can store on board 16 preset that can be recalled pushing the preset button. Once the preset will appear on the lower line of the display it will become automatically available after few seconds. If you desire t...
Ko70 output modules are using powercon connectors for power supply. It is possible, using the link connector, to have more modules on the same power supply line. You can wire a max of 4 modules on the same line if the use of them will be within the 50% of their max power. For full power use connect ...
User's manual p. 8 inspection and maintenance the k array systems are an assembly of mechanical devices, and are therefore subject to wear and tear over prolonged use, as well as damage from corrosive agents, extreme impact, or inappropriate use. Such inspection includes examination of all load-bear...
User's manual p. 9 ko70f - flat preset ko70d - 120 hz enhancement ko70i - infra sub preset with 1 mt delay ko70i_1, ko70d_1, ko70f_1 check for new presets on www.K-array.Com ko70 presets 15. Configurations kh15 kh15 kh15 kk200 kk200 kh4 ko70 ko70 ko70
Ko70 acoustics speakers power handling 2 x 2000 w (aes) max power 8000 w 1 impedance 2 x 8 Ω frequency range 25 hz - 120 hz spl 1w/1mt 99.5 db 2 maximum spl 136 db continuous - 140 db peak coverage omni crossover type dsp controlled frequency 150 hz transducers 2 x 21” neodymium speakers with 6” voi...
User's manual p. 11 k-array system - www.K-array.Com by hp sound equipment s.R.L. Viale roma 7/i 50037 san piero a sieve (firenze) italy - tel +39 055 8487222 fax e-mail: info@k-array.Com +39 055 8487238 k-notes.
