K-array Ko70 User Manual - P. 7
Ko70
output
modules are using PowerCon connectors for power supply. It is possible, using the link connector, to have more modules on the
same power supply line. You can wire a max of 4 modules on the same line if the use of them will be within the 50% of their max power. For
full power use connect max two modules on the same power supply line.
The Audio section includes a female balanced XLR connector and a male XLR connector wired in parallel. Thanks to these connectors it
is possible to feed a module and to send the same signal to another one through the LINK connector. It is possible to connect till 30
different modules in parallel on the same balanced line (with a source of 600 ohm
impedance). A Level Control potentiometer
(PAD) allows different set levels. The ground lift switch can help to solve ground loop problems due to wrong ground wiring.
10. POWER SUPPLY & AUDIO SECTION
P. 7
USER'S MANUAL
To connect high quantity of modules together by remote control, is
suggested to use K-array special 3 pole cables XLR adapters(K-XM45 and
K-XF45).
CAUTION
MAIN POWER SWITCH
MAIN AC POWER SUPPLY IN
MAIN AC POWER SUPPLY LINK OUT
AUDIO LEVEL & GROUND LIFT
GROUND CIRCUIT LOOP SWITCH
BALANCED AUDIO INPUT
BALANCED AUDIO PARALLEL LINK
!