K + H IS SUB 215 Operating Manual - page 6
Klein + Hummel
Operating Manual IS SUB 215
English
4
■ Technical Specifications
IS SUB 215
Drivers
2 x 15“ long excursion woofer, water resistant coating
System Design
Direct radiated, bass reflex
Smooth operating frequency range
38 Hz – 200 Hz +/- 3 dB
Sensitivity
98.0 dB SPL, 1 Watt, 1 meter
Impedance
4 Ohms (2 x 8 Ohm drivers in parallel)
Maximum SPL
134.0 dB SPL, peak, 180 ms sine-wave burst
Power Handling
2000 Watts, 7000 peak (10 ms)
Crossover
None
Input
2 x Speakon NL4, Input and Through
Terminal 2 ± to subwoofer drivers
Terminal 1 ± pass through only
Cabinet Material
18 mm Birch plywood
Cabinet Finish
Black structured lacquer (RAL 9005), white option (RAL 9010)
Grille
Powder coated steel Grille, foam backing
Rigging Attachment Points
(16) M10 thread points
Height x width x depth
430 x 827 x 725 mm (17 x 32.5 x 28.5 inches)
Weight
64 kg (141 lbs)
Accessories
None
■ Optional Accessories
None accessories are designed for the IS SUB 215
■ EC Declaration of Conformity
This equipment is in compliance with the essential requirements and other relevant provisions of Directives
2004/ 108/ EG and 2006/ 95/ EG. The declaration is available on the internet site at www.klein-hummel.com.
Before putting the device into operation, please observe any respective country-specific regulations.
■ Recycling
Attention to product quality in the design phase ensures, firstly, that products have a long life and that, secondly,
all parts of a product may be reused or recycled at the end of that life. An extensive product servicing network
ensures that products can be repaired in the event of the premature failure of a part, or as a way to prolong the life
of a product that would otherwise be considered a candidate for landfill. Eventually there comes a time when a
product is considered beyond repair (for economic reasons or lack of parts), so the parts must be disposed of in a
suitable manner. The disposal should conform to local environmental regulations and be conducted in an
authorized recycling facility. This product consists of some or all of these components:
Item Material
Recycling
Instructions
Loudspeaker
Steel, Plastic, Copper, Wool, Wood,
Electronic devices
Recycling only in authorized recycling plants
Packing Material
Cardboard, wood and/or plastics
Separate materials then recycle
User Manual
Paper and cardboard
Recycle