K-PO DX-5000 User Manual - page 4
1
FUNCTIONS & FEATURES
Large
LCD which displays frequency and other information
11
DUAL-DIGITAL READOUT FOR CHANNEL DISPLAY
21
USE EL technology for backlight
31
PA
41 、
CW、AM、FM、USB、LSB mode
A
51 、
B、C、D、E、F , 6 bands in total, with 60 channels total in
each band.
Frequency Tuning Step - 10HZ, 100HZ, 1KHZ or 10KHZ.
61
Multiple CLARIFIER Operating Modes
71
Flexible menu functions and PC programming software to meet
81
various requirements
ECHO Function
91
SQ, ASQ Function (FM and AM mode only)
111
RF GAIN ADJUSTMENT
111
RF PWR ADJUSTMENT
121
SCAN FUNCTION
131
RB FUNCTION
141
NB/ANL FUNCTION
151
DW DUAL-WATCH FUNCTION
161
BEEP VOICE PROMPT
171
+10KHZ Function
181
SWR
191
、
S/RF、DC Voltage display function
TOT function
211
HI-CUT FUNCTION
211
EMG CALL
221
SWR PROTECTION
231
POWER SUPPLIED VOLTAGE PROTECTION
241
Key-Lock Function
251
To use the radio, please connect the antenna to the location "B" on the
back panel of the radio first and then set the SWR (Standing Wave
Ratio) before transmitting. Failure to do so may result in
damage to the power amplifier, which is not covered by the guarantee.
RESET FUNCTION (Resume Factory Default)
This Radio has a 'RESET FUNCTION' to prevent accidents
and provide a solution for users who have changed functions
accidentally
and do not know how to resume normal settings. The
Radio will resume factory default once this function is activated.
How to Operate:
Step 1: Power off the radio.
Step 2: Press and hold FUNC and SCAN keys at the same time,
followed by powering on the radio.
Step3: Release the two keys when LCD displays "RES".
All former settings will be replaced by Factory Default value when
LCD displays "REND" .
WARNING: All settings will be replaced with Factory Default
values after carrying out the RESET FUNCTION.
WARNING