K-Star K-5-D Instruction Manual - page 6
6
Wiring Diagrams – All Models
2d)
Warning:
Ensure that the unit is properly grounded at the provided lug within the
unit and that the leakage collectors are separately grounded at the back
of the unit (marked “BONDING LUGS”). Improper installation may be a
potential cause of fi re, electric shock, personal injury or health hazards
and great care should be taken to avoid these. Make sure that all wiring
is secure.
7
3) Operating Instructions
Digital Thermostat Operating Instructions
At start up, the display will show the actual water temperature or
“OFF”.
Selecting temperature SCALE (choose F – Fahrenheit or
C – Celsius)
1a) to access the temperature SCale selection the unit has to
be in Set point mode (showing either “OFF” or decimal
points “---“).
1b) Press and hold POOL/SPA button for three seconds
and release when the display shows “SC“(for Scale).
The display will show “SC “for one second. Press UP or
DOWN button to toggle between Celsius and Fahrenheit
mode. Choose the scale setting to read: “C “for Celsius or
“F“for Fahrenheit.
1c) Press POOL/SPA button to accept your choice.
Must be strictly followed for warranty to be valid.
Before starting the heater, activate the pump and make sure that the air
is out of the heater chamber (Tank). Water circulation (Pump) must be on
at all times when unit is running.
3a)
1)