- DL manuals
- K-Star
- Ventilation Hood
- K1009 SERIES
- Operating Instructions Manual
K-Star K1009 SERIES Operating Instructions Manual
Summary of K1009 SERIES
Page 1
Read and save this instructions for domestic cooking only installer: leave this manual with the homeowner. Homeowner: cleaning, maintenance and operating instructions on the coming pages. Range hood item no.: k1009r/k1009c/k1009ra/k1009ca refered model no.: 3388f motor with ul certificate.
Page 2
1 your range hood’s specifications .….……………..………….2 important safety information……………………………… .…3-4 using your range hood………………………………..……………..5 maintaining and cleaning your range hood ……….6-8 installing/changing the carbon filter….………………………………………9-10 installation instructions ……………………….……...….11-19 ...
Page 3
2 congratulations on purchasing a range hood! To fully enjoy using your appliance long into the future, please firstly familiarise yourself with its specifications, safety advice and operational instructions included in this manual. You will also need this manual to ensure that your range hood has b...
Page 4
3 any installation work must be carried out by a qualified electrician or competent person. O the hood must be installed in accordance with the installation instructions and all measurements followed. O it is dangerous to alter the specifications or to modify this product in any way. Do not tamper w...
Page 5: Note
4 o please dispose of the packing material carefully – children are especially vulnerable to it. O dirty oil is an even greater fire risk. O always put lids on pots and pans when cooking on a gas cooker. O the manufacturer refuses to accept any responsibility for damages arising to the hood or it’s ...
Page 6: To Use Your Range Hood:
5 to use your range hood: 1) make sure it has been properly installed. 2) find the control panel. It is located at the front of the canopy, to the right. 3) the control panel contains buttons as shown in the figure below. These perform separate functions. You will need to understand what these butto...
Page 7: Important:
6 important: before cleaning, always ensure that you have switched your range hood off at the omni-polar switch, set at the wall from the cable: cleaning clean the external parts with mild liquid detergents on a damp cloth. Never use abrasive powder, corrosive solvents or brushes. Never insert point...
Page 8: Be Affected.
7 first remove the grille by pulling down on it. Undo the side catches. You can now clean the anti-grease filter grilles. Soak them for about one hour in hot water with a grease-loosening detergent then rinse off thoroughly with hot water. Repeat the process if needed. Refit the grease grille once i...
Page 9: Changing The Light Bulb
8 a) changing the light bulb before changing the light bulb, ensure that the appliance is not live (i.E., ensure that you have switched it off at the wall switch). Remove the metal anti-grease filters (see figure 2 below) and find the old bulb located in the light fixture up inside the exposed canop...
Page 10: Installing / Changing The
9 installing / changing the carbon filter. For model k1009r/k1009ra the cooker hood uses a pair of carbon filters to purify the air for the air recirculation function. You will find the round carbon filters are packed in a plastic bag besides the cooker hood. And the filters will attach to both side...
Page 11
10 for model k1009c/k1009ca the cooker hood uses a piece of carbon filters ( pls see fig 3) to purify the air for the air recirculation function. You will find the square carbon filters are packed in a paper box besides the cooker hood. And the filters will attach to both sides of the fan motor (ple...
Page 12
11 before installation and usage, read all the instructions and make sure that the voltage (v) and the frequency (hz) indicated on the identification plate (found inside your range hood) and all the data inside the appliance are exactly the same as the voltage and frequency in your home. Note: the m...
Page 13: Installation Instructions
12 the range hood must not be fitted above stoves with a radiant top plate. We recommend that at least two people install this hood. Note: your range hood should only be fitted on a wall. Do not position it any less than 28” above the hob. 1) remove the metal anti-grease filters (see figure at right...
Page 14: Installation Instructions
13 -------------------------------------------------------------------------- 3) using a drill bit with a 8 mm diameter, make holes in the wall where you have marked these positions (see below). ---------------------------------------------------------------------------------------------------------...
Page 15: Installation Instructions
14 ------------------------------------------------------------------------------------------- ------------------------------------------------------------------------------------------- 6) (extraction function only) connect the coupling to the top of the cooker hood (see below). Then connect the di...
Page 16: Fitting The Pipe –
15 fitting the pipe – once your cooker hood has been installed, you can now fit the pipe. 1) take the two casings ‘a’ and ‘b’: 2) rest the bottom of the casing ‘a’ on the top of the hood, taking care to position the tabs of the casing correctly on the back of the hood as shown as part ‘x’ in figure ...
Page 17: Installation Instructions
16 6) take the fixing bracket ‘g’ (fig. 4 – previous page), centre it with respect to the mark you previously made, keeping it in contact with the ceiling, and then mark the anchoring holes (‘h’). 7) using a drill bit with a 8mm diameter, make two holes on the fixing marks you previously made (see b...
Page 18
17 remove the metal grease filters from the hood slacken both anchoring screws “f” place the glass ‘q’ on the upper shelf of the hood, pushing it in towards the wall. Tightening the screws ‘f’ again in the hole and connecting them to the unit. Take care that the anchoring corner is firmly fastened, ...
Page 19
18 extraction operation – installation instructions ensure that you have fitted the union (‘n’) to the upper part of the hood using the packaged two screws supplied inside the packing (fig. 1 – on right). Using a 125 mm diameter pipe, connect the union (n) on the upper part of the hood (see fig. 1) ...
Page 20: Horizontal Adjustment.
19 * note on what to do if your range hood is the version that comes with a bracket. Please note that your range hood may include a lower bracket. If this is the case, you will need to have it installed as such. This will mean a slight change in how the cooker hood is to be installed from the proces...
Page 21: Symptom
20 if something has gone wrong with your range hood, checking against this chart might keep you from having to call for service. Symptom solution the range hood will not start! • check that the hood is connected to the electricity supply. • check that the fan speed control is set properly. The range...
Page 22
21 warranty we will warrant this product free from defects in material and quality for one year and motor for 5 years. If any problems occur from correct usage, please contact the service department for under warranty service. This warranty does not cover the following: the filter mesh and bulb. Com...
Page 23
22 k-star international group inc. K-star electronic appliance inc. Toll free:(800) 893-2168 email:info@kstarus.Com http://www.Kstarus.Com.