K-Star K1032 Operating Instructions Manual - page 7
Step 3: Relocate motor exhaust at the rear of unit
Position the unit on its back on a flat non abrasive surface – perpendicular to your working surface
(See Pic 4)
- Place hand to hold motor in position and ensure weight of motor is well supported (see Pic 4)
- This will ensure screws don’t get bent or broken
- Remove 4 screws that hold motor in place on the top side of the hood
- Ensure the motor weight is well supported by your hand as the last screw in place may break under
the weight of the motor
- Once the motor is set free from the hood, rotate motor clock wise to position venting outlet with rear
rectangular hole, ensuring that:
- Electric wire is located under the motor as you relocate the motor outlet (See Pic 5)
- Electric wire is not caught under the motor outlet (see Pic 6)
- 4 holes are aligned with screw holes at the rear
- Put unit upside down so the screw holes securing the motor are in a position facing you
- Install 4 screws to hold motor – Use a screw driver to perform operation – NOT A DRILL as it may
strip the motor housing thread (see Pic 7)
Pic 4
Pic 5
Pic 6
Pic 7