K3 Tango User Manual - page 8
3)Pairing headset with multi devices
The headset can connect with two Bluetooth cell phones at the same time.
The general pairing procedures are as follows:
1) Pairing the headset with device one
2) Turn on the headset and place into pairing mode again, then pair it
with device two
3) Operate device one to connect with headset. The headset has already
connected with two devices in this moment
Remarks:
l
The multi-pair function is off in factory set, please turn on this function as
following:
Turn on: long press
and button under standby mode (not connected
device), and release it until you hear four raise tone
Turn off: long press
and
button under standby mode (not
connected
device), and release it until you hear four fall tone
l
To improve the stabilization of headset, we suggest you turn off the
multi-pair function when you only connect with one cell phone.
4. Making a call with the headset
1) Basic operation
Functions
Status of
headset
Operation
Prompt tone
Cancel a call
Calling
Short press
once
One
short
tone
Answer a call
Incoming
call
ringing
Short press
once
Two
raise
tone
Reject a call
Incoming
call
ringing
Long press
about 2 seconds
and release it
until listen a
tone
Two fall tone
End a call
During a call
Short press
once
One
short
tone
Volume up
During a call
Short press
button
6