K40 RL200 Quick Reference Manual - Start-Up Sequence

Start-up Sequence  

(using factory default settings)

Your K40 RL360 /RL200 system will be ready for use following this

automatic start-up sequence:

1. Start your vehicle – The K40 is designed to turn on automati-

cally every time your vehicle is started. 

2. Listen for Test Scan – Both front and rear alert lights in your

dash will flash (K40 RL200 models have one alert light). The voice

will announce “K40 Scan, Active” then you will hear alerts for 

all bands. 

NOTE: If you don’t hear the test scan, press and release Power

button on the remote.

3. GPS Connection – After locating available satellites, the unit will

announce “GPS Connected”. 

NOTE: If you are in a location that prevents connection with GPS

(e.g. parking garage) your radar system will still protect you from all

threats. Once you drive to an unobstructed location, the GPS will

connect and you will hear “GPS Connected”. 

4. You’re ready to drive without limits!

4