K40 RLS2 Owner's manual - Mounting Instructions
Mounting and Powering the RLS2
Mounting Instructions
To help ensure that your RLS2 functions properly and
offers maximum protection, please follow these mounting
instructions:
1. Clean the area of the windshield where the RLS2 will
be mounted.*
2. Attach the supplied Windshield Mounting Bracket to
your vehicle’s windshield by firmly pressing the suction
cups and the bracket to the windshield.
a. Mount the bracket as low as possible near
the center of the windshield.
b. Do not mount the RLS2 behind wipers or any
metal obstructions.
c. Slide the RLS2 unit onto the bracket until it clicks
to complete the mounting.
d. The bracket may need to be leveled by carefully
bending it once the RLS2 is mounted.
*IMPORTANT NOTE: Some windshields include a metallic coating that can
significantly affect reception of radar signals. Consult with your dealer or
check your vehicle’s owner‘s manual to determine if your windshield has
such a coating.
Power Connection
1. Plug the small end of the supplied Power Cord into the
Power Input Jack on the left side of the RLS2.
2. Plug the large end of the Power Cord into your vehicle’s
12V outlet.
3. Switch on the RLS2 by rotating the Power On / Volume
Control Wheel located on the left side of the unit.
No power? See Troubleshooting Guide on page 16.
4