Kahuna LM7000 Instruction Manual - page 9
8
9
5-10cm
CHAIR INSTALLATION
cross screwdriver
Philip’s head screw
shoulder airbag air tube
OK
the hole of locating pin
locating pin
3. Install the shoulder airbag
1) find the 2 locating pin and screw holes.
2) Using the locating pin insert into the chair backrest, then a cross
screw driver to fix the philip's head screw.
3) Connect the tube with tube connector on the chair.
4) Zip up the opening after check each parts are secured.
5)Another side will follow the same steps.
1. As illustrated,
push the backrest downwards
and tilt chair on to its wheels at a 45° angle.
Slowly push and
maneuver the massage
chair to desired location. Lower massage
chair slowly and smoothly until it is fully flat
on the ground.
5. Place
the massage chair in an open area
6. Moving the massage chair.
*Do not move massage chair when occupied or in use.
*Moving the massage chair may cause damage to floors.
Floor protection is
recommended (e.g. rugs, carpet).
*Do not drop or suddenly let go of the chair when moving
as it may damage the chair.
*Two person participation is recommended. Please use
extra care when handling the massage chair.
- Allow sufficient space around the chair
for recline purposes.
5-10cm distance for the back side and
50cm in front of the footrest.
1.Remote Controller
REMOTE
CONTROLLER
1.Remote Controller
1
2
3
9
6
11
10
5
16
4
14
15
17
7
8
10
12
13
1. On/off Massage Chair
2. Pause Button
3. Zero Gravity Button
4. Auto button
5. Recline Adjustment
6. Heating Button
7. Position Adjust Button
8. Timer Button
9. Air Pressure Button
10. Air Massage Intensity
11. Area Adjustment Button
12. Fix Spot Massage
13. Manual Mode
14. Roller Width
15. Foot Roller Button
16. Speed Adjustment
17. Display