Kaiser Baas Alpha Drone Complete User Manual - page 14
25
26
FAQ
1. One of the motors is not spinning
Make sure that the larger cog on the
underside of the motor housing is
connected and moving properly. This
may require gently pressing on the
smaller cog to ensure that all cogs
are aligned correctly.
2. The Alpha Drone/Transmitter
LEDs keep flashing
The battery in the Alpha Drone or the
Remote Control Transmitter is running
low. In either case it is advisable to switch
off both devices and restart with fresh/
charged batteries.
3. The drone will not hover in one place
Try trimming your Alpha Drone
using the fine-tuning buttons to counter
any instability (Note: The Alpha Drone
will become slightly less stable when
running low on battery)
Place the Alpha Drone on level ground.
Then hold the Triming Reset button for 5
seconds until you hear a beep. The trim
and calibration have now been reset.
4. Footage is jumpy/grainy
Kaiser Baas recommends that a class 10
SDHC Micro SD card, with a capacity of
32GB or lower, is used to capture footage.
Dimensions:
33.1 X 33.1 X 7.7cm
Weight:
109g
Channels:
4
Battery:
550mAh
Motors:
4 X 3.7V, 2.5-2.6A, 12000rpm
Transmitter Battery: 6 X AA (not included)
Screen:
LCD Display
Frequency:
2.4 Ghz
Camera Resolution: 720P 30FPS
Photo:
2MP
Video format:
AVI
Photo format:
JPG
Memory:
Micro SD card (Max 32GB, not included)
PRODUCT SPECIFICATIONS