KAL-FIRE TWIN 38x15 Installation And Operating Instructions Manual - page 9
17
4 Operating instructions
The TWIN gas log fire’s are available with three types of controls. There
are appliances with manual control, ultrasound remote control and radio
remote control.
4.1
Manual controlled appliances
4.1.1
Lighting the burners
Make sure the gas tap is turned on. The main burner in the fire is ignited
by a pilot light, which in turn is ignited by a piezo element. Once the pilot
light is lit, it heats up a thermocouple which creates a small flow. This
flow holds the gas valve open. Should the pilot light go out, no gas can
keep flowing. This means you can be sure of safety at all times. The
ignition takes place as follows: (see figure 11).
Turn the ignition knob (1 in the above figure) to the “pilot light” position
(small flame) and press in. Gas will now flow to the pilot light. Keep the
knob pressed in, and turn it to the left, “” position; you will now hear
the piezo ignition clicking and see a spark jump over to the pilot light;
keep this knob pressed in until the pilot light is burning steadily. (This
can take longer straight after mounting because the gas pipe still has to
fill with gas).
When the pilot light is burning, keep the knob (1) pressed in for
approximately another 20 seconds, otherwise repeat the above
operation.
1
2
Figure 11: Manually controlled appliance
18
Now release the knob (1). If the pilot light does not keep burning, wait
for 3 minutes and then repeat the above steps.
Now turn the knob (1) fully in the opposite direction, as far as the
position with the “big flame”; now you can adjust the flames to the
desired size, by means of the right-hand knob (2).
4.1.2
Extinguishing the burners
The burners can be extinguished as follows: turn the ignition knob (1) a
quarter turn to the left as far as the “pilot light” position. The burners will
now be extinguished, however the pilot light will stay alight. The burners
can be re-ignited by turning the knob back to the position with the
“flames”.
If you do not wish to use the appliance over an extended period of time,
you can turn the knob (1) all the way back to the symbol “z”, which will
also extinguish the pilot light, at the same time you can also turn off the
gas tap.