KAM K-Strip6 Instruction Manual - page 5
Master/Slave operation
When the Master unit is set to Auto, Soun or SHOU modes and the Slave (or Slaves) are set to A001, the Slave units will follow
the Master unit output.
Remote control operation
The maximum distance is 10-15 metres. There should be no obstacles between the remote control and the unit. Point the remote
control directly towards the unit.
Product specification
Mains input
AC100~240V, 50/60Hz
Control modes
DMX512
Auto
Sound-to-Light
Master/Slave
Wireless remote control
Beam angle
18°
Light source
6 x 3w RGB 3-in-1 LEDs
Protection rating
IP20
Operating temperature
10~40°
DMX512 connections
3 pins XLR male/female
DMX512 channels
3/7/18
Dimensions (WxDxH)
404 x 70 x 105mm (WxDxH not inc brackets)
Nett weight
3Kg
Button
Function
BLACK OUT On / Off
AUTO
Auto mode
SOUND
Sound-to-Light mode
ADDR
DMX512 mode. Press the plus or minus buttons to set the address.
SPEED
Auto speed 1-99. Press the plus or minus buttons to set the speed.
COLOR
Colour. Press the plus or minus buttons to set the colour.
DMXCH
DMX channel. Press the plus or minus buttons to set the DMX channel.
MANUAL
Brightness. Press the R/G/B buttons and the MANUAL button then press
the plus or minus buttons to adjust the brightness.
SHOW
Pre-programmed shows. SH1-SH14. Press the plus or minus buttons to choose.
R
Red LED
G
Green LED
B
Blue LED
A
No Function
UV
No Function
W
No Function
+
Plus button or Up button
0
Black out
-
Minus button or Down button
1-9
Colour choice.