KAM KMH SERIES Instruction Manual - page 4
Function Setting blue LED display(s)
Quick Start Guide
Running in Auto mode
1) Use the rear panel Function Setting MENU button on the first moving head to find and select the AUto function.
2) Press the ENTER button to make your selection.
3) Select any other moving heads on the unit and select Addr and then set each unit to the same number e.g d001.
4) Press the ENTER button to make your selection.
Your Kam KMH moving head(s) will now operate in Auto mode.
Running in DMX Master/Slave mode (where all heads perform in exactly the same way)
Whether you have a 4, 2 or single head unit, this is the settings to get all heads to ‘copy’ the actions of the first head or unit.
Start by setting the first unit or head to be the Master by pressing the MENU button and selecting AUTo followed by the ENTER
button. Next set all other heads/units to be Slaves by pressing their MENU button until the display shows Addr, press ENTER
then set each head/unit to the same number e.g. d001. Then press the ENTER button to confirm your choice. Each head
connected to the Master will now work as a Slave. This process needs to be completed for each head and/or units. If you are
connecting multiple units, these will need to be connected via a DMX cable. The routing is as follows: connect a DMX cable from
the DMX Output of the Master unit to the DMX Input of the next unit, then another DMX cable from the second unit’s DMX Output
to the DMX input of the next unit and so on for all units connected in the chain.
Running in Individual DMX mode
Whether you have a 4, 2 or single head unit, this is the settings to control each head seperately and have full control over its
individual features. This makes this product great for installations and creative DJs. All KMH units have two DMX operating
modes, you can choose either 13 or 9 channel operation.
Setting the DMX address
Set each head to DMX address mode by pressing the MENU button until the display shows Addr press the ENTER button and
then you will see the address menu e.g. d001. This number is the DMX address of each individual head. Choose a number and
then press the ENTER button to confirm your choice.
Display Function
Addr Set the DMX address for the unit.
Chnd Set the DMX channel mode. Either 9 or 13 channels.
AUto
Set the unit to Auto mode.
Set the pre-programmed show (from 01-99).
SoUd
Set the unit to Sound-to-Light mode.
Set the pre-programmed show (from 01-99).
tESt Set the unit to run through a series of self tests.
dLEd
Set the rear panel Function Setting LED display to turn off
automatically (OFF) or remain on (ON).
diSP
Rotate the rear panel Function Setting LED display 180°.
Use when unit is mounted upside down.
tiNE Unit runtime.
CPU
Software version.
rSt
Resets the unit.