KAM KWD220 HH Instruction Manual - page 3
Before use
The handheld microphones requires 2 x AA batteries in each microphone. Please use quality branded batteries for
the best results. Ensure the batteries are fitted correctly and that the polarity is correct. The battery LED will flash
when the battery power level is low.
Place the reciever on a suitable flat surface. Plug in the DC mains adaptor into the reciever. Connect the 6.35mm
mono jack from the reciever into a suitable mic/mixer input.
Important note
Before you plug the DC adaptor into a suitable mains voltage supply, 240v or 110v AC. Please check the voltage
input of the power supply is correct, as different countries use different voltages.
Top panel
1. Channel 1 volume control
2. Channel 1 pairing LED
3. Channel 1 RF LED
4. Power on LED
5. Channel 2 RF LED
6. Channel 2 pairing LED
7. Channel 2 volume control
Rear panel
1. Channel 2 dipswitch
2. 6.35mm audio output to mixer / mic input socket
3. DC mains adaptor input
4. Power on/off switch
5. Channel 1 dipswitch
6. Channel 1 aerial
7. Channel 2 aerial
5
1
2
4
6
7
3
5
1
2
4
6
7
3