Kambrook KSM400 Instruction booklet - Cleaning After Use
11
Cleaning After Use
1. Always ensure that the Speed
Control Dial is in the ‘OFF’ position
and that the power is switched
off at the power outlet, then
remove the power cord from
the power outlet.
2. Eject the beaters/dough hooks
from the mixer head.
3. To remove the mixer head for
cleaning, press and hold the ‘Mixer
Release Lever’ and lift the mixer
head from the mixer stand and pull
upwards until the mixer head is fully
clear of the mixer stand. Release
the ‘Mixer Release Lever’.
4. Wipe the mixer head, mixer
stand and revolving turntable
with a soft, damp cloth then
dry thoroughly.
5. Wipe any excess food particles
from the power cord.
6. Wash the mixing bowls, beaters
and dough hooks in warm soapy
water with a soft clean cloth.
Rinse and dry thoroughly. Mixing
bowls may also be washed in
the dishwasher.
7. Do not allow the mixing bowls/
beaters/dough hooks to soak in
water for an extended period
of time, as this may damage
the metal finish.
8. Do not place any part of the
Stand Mixer except the mixing
bowls in the dishwasher.
Care, Cleaning and Storage
NOTE: Do not use abrasive
scouring pads or cleaners when
cleaning the mixing bowls/
beaters/dough hooks as these
may scratch the surface. Also
ensure that the mixing bowls/
beaters/dough hooks are not
soaked in water for an extended
period of time, i.e. for several
hours or overnight, as this may
damage the metal finish. Do not
wash or soak the mixer stand in
water or any other liquid. Clean
with a damp cloth and dry
thoroughly. Do not allow water or
any other liquid to enter the gear
system as damage may result.
CAUTION: Never immerse
the Stand Mixer, power
cord or plug in water or
any other liquid.
Storage
Your Kambrook Stand Mixer should
be kept in a convenient position
on your kitchen bench top or in
an accessible cupboard.
Always unplug your Kambrook Stand
Mixer from the power outlet before
storing. Place the revolving turntable
in the small bowl position. Insert the
beaters into the correct mixer head
sockets. Store the mixing bowls on the
turntable with the small bowl sitting
inside the large mixing bowl. Place
the dough hooks inside the small bowl
and lower the mixer head into the
horizontal position. The beaters will
help hold the bowl in position.