Summary of KSL1W9
Page 1
User manual ksl1w9.
Page 2
I n d e x summarize ......................................................................... 3 safety instruction ................................................................ 3 outside size picture ............................................................. 4 main function ......................
Page 3
Summarize thank you for purchasing our led lighting. Please read these instructions carefully before begin and operate the fixtures according to these instructions to avoid any possible damages and accidents causes by misusage. Products introduce this led kksl1w9 light is uses aluminum shell, design...
Page 4
● make sure the power supply voltages are consistent with this lights ，ensure the use of voltage is in the range of the request technical parameter. ●before the installation, please check the light’s fasteners and mechanical structure have been received in good condition and appear no damage. ●this ...
Page 5
Main function • high quality led: low consumption, brightness, stable capability and long life • each color of led with 256 dimming. Rgb can make over 16.7 million colors • dim 0%-100%, strobe、gradual change、jumping change • dmx512 controller • auto run /sound activated/master slave/interconnected m...
Page 6
Display operation • menu : access the menu or return to a previous menu option • enter: select the current menu option • up: menu selection or parameter increments • down: menu selection or parameters decrease operating instruction 1. Menu is used to access the menu or return to a previous menu opti...
Page 7
2. Press enter to access the further menu setting. This process can be saved automatically; that means you will enter the process saved previously when you activate the light next time. For example, if you want to choose dmx mode a001, operate as follows: • press menu, go back to the initial setting...
Page 8
Operating control instruction master/slave master ：the master should set as built-in program and shows” p - x – x” send out synchronization signals. To avoid the host signal and dmx512 signals interfere with each other, should cut off the dmx512 signals. The signal lines are longer than 60 meters sh...
Page 9
A resistance120Ω （ 1/4w ） at the end of the dmx connecting as below: the conversion between 3pin and 5 pin xlr if the output cable of dmx512 controller is the 5pin, please use 1pc 5pin to 3pin cable.
Page 10
Connecting picture.
Page 11
Exploeded views.
Page 12
Problem analyze problem checking way can not turn on the light check the power source plug is in normal or not check the switch of the lights is off or on check it the fuse if in normal dmx can not control it check the dmx cable is connect to the lights or not check the dmx512 controller work in nor...
Page 13
Some of the led not light use the multimeter to check if the led is bright or not, of not, please change the led check whether current limiting resistor is normal or not check constant current ic is normal or not (compared with the normal ic) single color leds always bright/not bright check the swit...
Page 14
Technical specification • input voltage:220v/50hz • consume：15w • lamp type：high power led • lamp spec：3-in-1 9w 1pcs • control signal：dmx512, sound activated, auto run • control mode： dmx/ auto run/sound activated / master and slaver • beam angle: 12° • projecting distance:30m • projecting angle(y ...
Page 15
Copyright 2012 kandolite. All rights reserved. Due to continuous improvements and innovations, specifications may change without notice..